Features:
- Industrial Design: 3.5in external HDD case of USB interface
- Sing le 12V/1.5A power adapte r. USB-IDE device must
be self-powered due to the power need of the hard disk
drive.
- The USB interface is
a. Complies with USB-IF specifications for USB 2.0, the
USB Mass Storage Class, and the USB Mass Storage Class
Bulk-Only Transport Specification
b. Operates at high (480-Mbps) or full (12-Mbps) speed
c. Complies with ATA/ATAPI-6 Draft Specification
d. Supports 48-bit addressing for large hard drives, with
virtually no limit on the capacity of hard disk drives
e. Supports PIO modes 0, 3, 4, and UDMA modes 2, 4
f. Support for ATA/ATAPI devices configured either as
master or slave
g. Supports suspend/resume operation.
- Compatible with WindowsR 98se, Me, 2000, and XP and
MACR 9.x and X. For WindowsR OS, no device driver is needed
except WindowsR 98se.
- Optional DES 40- or 64-bit encryption module can be
added for WindowsR 2000 and XP and MACR X, providing superior
physical data security protection for valuable data without
losing the portability.
- Note:
(1). This device does not support IDE removable media
devices. Changes in media state are not reported to the
operating system so users will be unable to eject/reinsert
media properly. This may result in lost or corrupted data.
I.e., no hot-swap/plug/remove of IDE device is possible
when the device is powered on.
(2). The maximum speed described above is the “specification”
figures defined in USB2.0. In real application case, the
maximum speed of the device can perform is largely determined
by the host (e.g )
System Requirements
Windows 98SE/ME/2000/XP/Mac OS |